2022 Kawasaki KLX 110R Lubrication Owner’s Manual

2022 Kawasaki KLX 110R Lubrication

Lubrication

Lubricate the areas shown in the illustrations of this section with either motor oil or regular grease in accordance with the Periodic Maintenance Chart and whenever the vehicle has been operated under wet or rainy conditions, especially after using a high-pressure spray washer. Before lubricating apart, clean off any rust with rust remover and wipe off any grease, oil, dirt, or grime.

General Lubrication

• Apply motor oil to the following pivots:
• Clutch Lever (KLX110D Model)
• Front Brake Lever
  
• Rear Brake Pedal
• Rear Brake Rod Joint
• Kick Pedal
• Footpeg
  
• Shift Pedal
• Side Stand
• Apply an aerosol cable lubricant with a pressure lubricator on all cables:
• Clutch Cable (KLX110D Model)
• Throttle Cable

Cable Lubrication

Apply grease to the following points:

• Clutch Inner Cable Upper End (KLX110D Model)
• Throttle Inner Cable Upper End
• Upper End
  

Chain Lubrication

Lubrication is necessary after riding through rain or on wet roads, or any time that the chain appears dry. Use a lubricant for drive chains. If the chain is especially dirty, clean it using a cleaner for drive chains following the instructions supplied by the chain cleaner manufacturer.

• Apply lubricant to the sides of the rollers so that it will penetrate to the rollers and bushings. Wipe off any excess lubricant.
  
• Wipe off any lubricant that gets on the tire surface.