2022 Kawasaki CONCOURS 14ABS Final Gear Case Oil Owners Manulas

2022 Kawasaki CONCOURS 14ABS Final Gear Case Oil

Final Gear Case Oil

Oil Level Inspection

• Use the center stand by holding the motorcycle vertical on level ground.
• Remove the filler cap.
  NOTICE
  Be careful not to allow any dirt or foreign materials to enter the gear case.
• Check the oil level. If it is low, add oil as necessary. The oil level should come to the bottom of the filler opening with the motorcycle held vertical on level ground.
  • A. Bottom of Filler Opening
  • B. Filler Cap

NOTE

• Use the same type and brand of oil that is already in the final gear case.
• Install the filler cap with a new O-ring Tighten it to the specified torque.

NOTE
Replace the O-ring with a new one.

Tightening Torque

• Filler Cap:
  • 6.0 Nm (0.61 kgfm, 53 in 1b)

Oil Change

NOTE

• Final gear case oil drains easily and picks up any sediment when the oil is warmed up by running the motorcycle.
• lf a torque wrench is not available, this item should be serviced by an authorized Kawasaki dealer.
• Put the motorcycle on its side stand.
• Place an oil pan beneath the gear case.
• Remove the filler cap and drain bolt.

WARNING
Gear case oil is a toxic substance. Dispose of used oil properly. Contact your local authorities for approved disposal methods or possible recycling.

• A. Drain Bolt
• B. Filler Cap

WARNING
Oil on tires can make them slippery which can cause an accident and injury. When draining or filling the gear case, be careful that no oil gets on the tires or rims. Clean off any oil that inadvertently gets on them with soap and water.

• After the oil has completely drained out, install the drain bolt with a new gasket. Tighten it to the specified torque.

NOTE
Replace the gasket with a new one.

Tightening Torque

• Final Gear Case Oil Drain Bolt:
  17 Nm (1.7 kgfm, 13 ft-lb)
• With the motorcycle held vertical on level ground, fill the gear case up to the top thread of the filler opening with the oil specified below without turning the rear tire.
• If the rear tire is turned, it is necessary to leave it for about six minutes.

Final Gear Case Oil

NOTE

“GL-5” indicates a quality and additive rating. “GL-6” rated hypoid gear oils can also be used.

• Install the filler cap with a new O-ring. Tighten it to the specified torque.

NOTE
Replace the O-ring with a new one.

Tightening Torque

• Filler Cap:
  • 6.0 N m (0.61 kgfm, 53 in-lb)