2022 Kawasaki VERSYS 650 ABS Coolant Owners Manual

2022 Kawasaki VERSYS 650 ABS Coolant

Coolant

Coolant Level Inspection

• Position the motorcycle so that it is perpendicular to the ground.
• Check the coolant level through the coolant level gauge on the reserve tank located at the back of the middle fairing. The coolant level should be between the F (Full) and L (Low) level lines.

A. F (Full) Level Line
B. L (Low) Level Line
C. Reserve Tank

NOTE

• Check the level when the engine is cold (room or atmospheric temperature).
• If the amount of coolant is insufficient, add coolant into the reserve tank.

Coolant Filling Quick Rivet Removal

A. Quick Rivet
B. Center Pin
C. Push in.

Quick Rivet Installation

A. Quick Rivet
B. Center Pin
C. Pull up fully.
D. Push in.

• Remove the quick rivet.
• Remove the bolt and washer.
• Remove the bolt and collar.

A. Quick Rivet
B. Bolt and Washer
C. Bolt and Collar

• Pull the right inner cover inward to clear the projections.

A. Projections

• Remove the cap from the tank and add coolant filler opening between and L (Low) level lines. the reserve through the F (Full)

A. Reserve Tank Cap

NOTE

• In an emergency you can add water alone to the coolant reserve tank, however, it must be returned to the correct mixture ratio by the addition of antifreeze concentrate as soon as possible.

NOTICE
If coolant must be added often, or the reserve tank completely runs dry, there is probably leakage in the system. Has the cooling system been inspected by your authorized Kawasaki dealer.

• Install the reserve tank cap.
• Insert the projections of the right inner cover are inserted into the slot and recesses in order from the rear of the vehicle.

A. Projections
B. Recesses
C. Slot

• Install the washer and collar
• Tighten the bolts.
• Install the quick rivet.

A. Quick Rivet
B. Washer and Bolt
C. Collar and Bolt

Coolant Change
Has the coolant been changed by an authorized Kawasaki dealer.

Coolant Requirement

WARNING
Coolant-containing corrosion inhibitors for aluminum engines and radiators include harmful chemicals to the human body. Drinking coolant can result in serious injury or death. Use coolant in accordance with the instructions of the manufacturer. Use a permanent type of antifreeze (soft water and ethylene glycol plus corrosion and rust inhibitor chemicals for aluminum engines and radiators) in the cooling system. On the mixture ratio of coolant, choose the suitable one referring to the relation between freezing point and strength directed on the container.

NOTICE
If hard water is used in the system, it causes scale accumulation in the water passages and considerably reduces the efficiency of the cooling system.

NOTE

• A permanent type of antifreeze is installed in the cooling system when shipped. It is mixed at 50% and has a freezing point of—350C (—31 OF).