2022 Jeep Wrangler TrailCam System User Manual
TRAILCAM SYSTEM — IF EQUIPPED
Your vehicle may be equipped with a TrailCam that allows you to you see an on-screen image of the front view of your vehicle. The image will be displayed on the touchscreen display along with a caution note “Check Entire Surroundings” across the top of the screen.
NOTE
- The system will stay active while in 4WD Low.
- The TrailCam system has programmable settings that may be selected through the Uconnect system
Manual Activation Of The TrailCam
TrailCam view can be activated via the below methods:
- Press the FWD Camera button on the controls screen.
- Press the Forward Facing Camera button on the apps menu.
- Press the TrailCam button on the Off-Road Pages.
- Press the Off Road+ button when “Auto Launch Off Road+” (if equipped) has been selected under camera settings.
- The TrailCam view can also be activated by pressing the icon on the Back-Up Camera view. The Back-Up Camera view can also be activated by pressing the icon on the TrailCam view.
- When the vehicle is shifted out of REVERSE with Camera Delay turned off and TrailCam view is active, the TrailCam mode is exited and the previous screen appears again.
- When the vehicle is shifted out of REVERSE with Camera Delay turned on and the TrailCam view is active, the TrailCam image will be displayed for up to 10 seconds unless the vehicle speed exceeds 8 mph (13 km/h), the transmission is shifted into PARK, the ignition is placed in the OFF position, or the touchscreen button X to disable the display of the TrailCam view is pressed.
- Whenever the TrailCam image is activated through the Manual Activation Methods, and the vehicle speed is greater than or equal to 8 mph (13 km/h), a display timer for the image is initiated. The image will continue to be displayed until the display timer exceeds 10 seconds.
NOTE
- If the vehicle speed remains below 8 mph
(13 km/h) while in 2WD or 4WD High, the TrailCam image will be displayed continuously until deactivated via the touchscreen button X, the transmission is shifted into PARK, or the ignition is placed in the OFF position. - The touchscreen button X to disable the display of the camera image is made available ONLY when the vehicle is not in REVERSE.
The TrailCam view will stay active regardless of the vehicle speed and time while in 4WD Low.
Cleaning The TrailCam
Press and hold the Clean Camera soft button located on the TrailCam view to wash the TrailCam. Washer fluid will stop when the button is released.
- The camera can be washed up to 20 seconds at a time while holding the button.
- The Clean Camera system is not available when windshield washing is in process.
When enabled, active dynamic Tire Lines are projected on the ground plane of the TrailCam view based on the steering wheel position.