2022 Jeep Wrangler ParkView Back Up Camera User Manual

2022 Jeep Wrangler ParkView Back-Up Camera User Manual

PARKVIEW REAR BACKUP CAMERA

The Parkview Rear Back-Up Camera allows you to see an on-screen image of the rear surroundings of your vehicle whenever the gear selector is put into REVERSE. The image will be displayed in the touchscreen display along with a caution note to “Check Entire Surroundings” across the top of the screen. After five seconds this note will disappear. The Parkview camera is located on the rear of the vehicle in the center of the spare tire.

Manual Activation Of The Rear View Camera

• Press the Controls button located on the bottom of the Uconnect display.
• Press the Back-Up Camera button to turn the Rear View Camera system on.

When the vehicle is shifted out of REVERSE with the Camera delay turned off, the rear Camera mode is exited and the previous screen appears again. When the vehicle is shifted out of REVERSE with Camera delay turned on, the rear camera image will be displayed for up to 10 seconds unless the vehicle speed exceeds 8 mph (13 km/h), the transmission is shifted into PARK, the ignition is placed in the OFF position, or the touchscreen button X to disable the display of the Rear View Camera image is pressed. Whenever the Rear View Camera image is activated through the Back-Up Camera button in the Controls menu, and the vehicle speed is greater than, or equal to, 8 mph (13 km/h), a display timer for the image is initiated. The image will continue to be displayed until the display timer exceeds 10 seconds.

NOTE

• If the vehicle speed remains below 8 mph (13 km/h), the Rear View Camera image will be displayed continuously until deactivated via the touchscreen button X, the transmission is shifted into PARK, or the ignition is placed in the OFF position.
• The touchscreen button X to disable the display of the camera image is made available ONLY when the vehicle is not in REVERSE. When enabled, active guidelines are overlaid on the image to illustrate the width of the vehicle and its projected backup path based on the steering wheel position. A dashed center line overlay indicates the center of the vehicle to assist with parking or aligning to a hitch/receiver.
• When enabled, fixed guidelines are overlaid on the image to illustrate the width of the vehicle.
• Different colored zones indicate the distance to the rear of the vehicle.
  The following table shows the approximate distances for each zone:

  Zone	Distance To The Rear Of The Vehicle
  Red	0 – 1 ft (0 – 30 cm)
  Yellow	1 ft – 6.5 ft (30 cm – 2 m)
  Green	6.5 ft or greater (2 m or greater)

WARNING

Drivers must be careful when backing up even when using the ParkView Rear Back-Up Camera. Always check carefully behind your vehicle, and be sure to check for pedestrians, animals, other vehicles, obstructions, or blind spots before backing up. You are responsible for the safety of your surroundings and must continue to pay attention while backing up. Failure to do so can result in serious injury or death.

CAUTION

• To avoid vehicle damage, ParkView should only be used as a parking aid. The Parkview camera is unable to view every obstacle or object in your drive path.
• To avoid vehicle damage, the vehicle must be driven slowly when using Parkview to be able to stop in time when an obstacle is seen. It is recommended that the driver look frequently over his/her shoulder when using Parkview.

NOTE
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the lens, rinse with water, and dry with a soft cloth. Do not cover the lens.