2022 Jeep Grand Cherokee Recreational Towing (Behind Motorhome)

Jeep-logo

2022 Jeep Grand Cherokee Recreational Towing (Behind Motorhome)

Recreational Towing (Behind Motorhome)

TOWING THIS VEHICLE BEHIND ANOTHER VEHICLE

Towing Condition Wheels OFF The Ground Two-Wheel Drive Models Four-Wheel Drive Models Without 4WD LOW Range Four-Wheel Drive Models With 4WD LOW Range

Flat Tow

NONE

NOT ALLOWED

NOT ALLOWED

See Instructions

l Transmission in PARK

l Transfer case in N (NEUTRAL)

l Tow in forward direction

Dolly Tow Front NOT ALLOWED NOT ALLOWED NOT ALLOWED
Rear OK NOT ALLOWED NOT ALLOWED
On Trailer ALL OK OK OK

NOTE:

  • When towing your vehicle, always follow applicable state and provincial laws. Contact state and provincial Highway Safety offices for additional details.
  • Vehicles equipped with Quadra-Lift must be placed in Transport Mode before tying them down (from the body) on a trailer or flatbed truck Ú page 138. If the vehicle cannot be placed in Transport mode (for example, engine will not run), tie-downs should be fastened over the tires using specific straps (not to the body). Failure to follow these instructions may cause fault codes to be set and/or cause loss of proper tie-down tension.

RECREATIONAL TOWING — TWO-WHEEL DRIVE MODELS

DO NOT flat tow this vehicle. Damage to the drivetrain will result.
Recreational towing (for two-wheel-drive models) is allowed ONLY if the rear wheels are OFF the ground. This may be accomplished using a tow dolly or vehicle trailer. If using a tow dolly, follow this procedure:

  1. Properly secure the dolly to the tow vehicle, following the dolly manufacturer’s instructions.
    NOTE:
    If vehicle is equipped with Quadra-Lift air suspension, ensure the vehicle is set to Normal Ride Height.
  2. Drive the rear wheels onto the tow dolly.
  3. Firmly apply the parking brake. Shift the transmission into PARK.
  4. Turn the ignition OFF.
  5. Properly secure the rear wheels to the dolly, following the dolly manufacturer’s instructions.
  6. Install a suitable clamping device, designed for towing, to secure the front wheels in the straight position.

CAUTION!
Towing with the rear wheels on the ground will cause severe transmission damage. Damage from improper towing is not covered under the New Vehicle Limited Warranty.

RECREATIONAL TOWING — QUADRA-TRAC I (SINGLE-SPEED TRANSFER CASE WITHOUT 4WD LOW RANGE) FOUR-WHEEL DRIVE MODELS

Recreational towing is not allowed. These models do not have a N (NEUTRAL) position in the transfer case.

NOTE:
This vehicle may be towed on a flatbed or vehicle trailer provided all four wheels are OFF the ground.

CAUTION!
Towing this vehicle in violation of the above requirements can cause severe transmission and/or transfer case damage. Damage from improper towing is not covered under the New Vehicle Limited Warranty.

RECREATIONAL TOWING — QUADRA–TRAC II WITH 4WD LOW RANGE

The transfer case must be shifted into N
(NEUTRAL) and the transmission must be in PARK (P) for recreational towing. The N (NEUTRAL) selection button is adjacent to the air suspension switch. Shifts into and out of transfer case N
(NEUTRAL) can take place with the selector switch in any mode position.

CAUTION!

  • DO NOT dolly tow any 4WD vehicle. Towing with only one set of wheels on the ground (front or rear) will cause severe transmission and/or transfer case damage. Tow with all four wheels either ON the ground or OFF the ground (using a vehicle trailer).
  • Tow only in a forward direction. Towing this vehicle backward can cause severe damage to the transfer case.
  • The transmission must be in PARK for recreational towing.
  • Before recreational towing, perform the procedure outlined under “Shifting into N
    (NEUTRAL)” to be certain that the transfer case is fully in N (NEUTRAL). Otherwise, internal damage will result.
  • Towing this vehicle in violation of the above requirements can cause severe transmission and/or transfer case damage. Damage from improper towing is not covered under the New Vehicle Limited Warranty.
  • Do not use a bumper-mounted clamp-on tow bar on your vehicle. The bumper face bar will be damaged.

Shifting Into Transfer Case N (NEUTRAL)

WARNING!
You or others could be injured or killed if you leave the vehicle unattended with the transfer case in the N (NEUTRAL) position without first fully engaging the parking brake. The transfer case N (NEUTRAL) position disengages both the front and rear driveshafts from the powertrain and will allow the vehicle to roll, even if the transmission is in PARK. The parking brake should always be applied when the driver is not in the vehicle.

CAUTION!
It is necessary to follow these steps to be certain that the transfer case is fully in N (NEUTRAL) before recreational towing to prevent damage to internal parts.

Use the following procedure to prepare your vehicle for recreational towing:

  1. Bring the vehicle to a complete stop on level ground, with the engine running.
  2. Press and hold the brake pedal.
  3. Shift the transmission into NEUTRAL.
  4. If vehicle is equipped with Quadra-Lift air suspension, ensure the vehicle is set to Normal Ride Height.
    NOTE:
    • Steps 1 through 4 are requirements that must be met before pushing the N
      (NEUTRAL) button, and must continue to be met until the shift has been completed. If any of these requirements are not met before pushing the N (NEUTRAL) button or are no longer met during the shift, then the N (NEUTRAL) indicator light will flash continuously until all requirements are met or until the N (NEUTRAL) button is released.
    • The ignition must be in the ON/RUN position for a shift to take place and for the position indicator lights to be operable. If the ignition is not in the ON/RUN position, the shift will not take place and no position indicator lights will be on or flashing.
    • A flashing N (NEUTRAL) position indicator light indicates that shift requirements have not been met.
    • If the vehicle is equipped with Quadra-Lift air suspension, the engine should be started and left running for a minimum of 60 seconds (with all the doors closed) at least once every 24 hours. This process allows the air suspension to adjust the vehicle’s ride height to compensate for temperature effects.
  5. Using a ballpoint pen or similar object, push and hold the recessed transfer case N
    (NEUTRAL) button (located by the selector switch) for more than four seconds. The light behind the N symbol will blink, indicating shift in progress. The light will stop blinking (stay on solid) when the shift to N (NEUTRAL) is complete. A “FOUR WHEEL DRIVE SYSTEM IN NEUTRAL” message will appear in the instrument cluster.2022-Jeep-Grand-Cherokee-RECREATIONAL-TOWING-(BEHIND-MOTORHOME)-fig1
  6. After the shift is completed and the N
    (NEUTRAL) light stays on, release the N
    (NEUTRAL) button.
  7. Shift the transmission into REVERSE or DRIVE.
  8. Release the brake pedal for five seconds and ensure that there is no vehicle movement.
  9. Press and hold the brake pedal. Shift the transmission back into NEUTRAL.
  10. Firmly apply the parking brake.
  11. With the transmission and transfer case in N (NEUTRAL), push and hold the ENGINE START/STOP button until the engine turns off.
  12. Place the transmission gear selector in PARK. Release the brake pedal.
  13. Push the ENGINE START/STOP button twice (without pressing the brake pedal), to turn the ignition to the off position.
  14. Attach the vehicle to the tow vehicle using a suitable tow bar.
  15. Release the parking brake.

Shifting Out Of Transfer Case N (NEUTRAL)

Use the following procedure to prepare your vehicle for normal use:

  1. Bring the vehicle to a complete stop, leaving it connected to the tow vehicle.
  2. Firmly apply the parking brake.
  3. Start the engine.
    NOTE:
    • Steps 1 through 5 are requirements that must be met before pushing the N
      (NEUTRAL) button, and must continue to be met until the shift has been completed. If any of these requirements are not met before pushing the N (NEUTRAL) button or are no longer met during the shift, the N (NEUTRAL) indicator light will flash continuously until all requirements are met or until the N (NEUTRAL) button is released.
    • The ignition must be in the ON/RUN position for a shift to take place and for the position indicator lights to be operable. If the ignition is not in the ON/RUN position, the shift will not take place and no position indicator lights will be on or flashing.
    • A flashing N (NEUTRAL) position indicator light indicates that shift requirements have not been met.
  4. Press and hold the brake pedal.
  5. Shift the transmission into NEUTRAL.
  6. Using a ballpoint pen or similar object, push and hold the recessed transfer case N (NEUTRAL) button (located by the selector switch) for one second.2022-Jeep-Grand-Cherokee-RECREATIONAL-TOWING-(BEHIND-MOTORHOME)-fig2
  7. When the N (NEUTRAL) indicator light turns off, release the N (NEUTRAL) button. After the N (NEUTRAL) button has been released, the transfer case will always shift to 4WD HI.
  8. Shift the transmission into PARK. Turn the engine off.
  9. Release the brake pedal.
  10. Disconnect the vehicle from the tow vehicle.
  11. Start the engine.
  12. Press and hold the brake pedal.
  13. Release the parking brake.
  14. Shift the transmission into REVERSE or DRIVE, release the brake pedal, and check that the vehicle operates normally.

Leave a Comment