2022 Jeep Grand Cherokee Active Lane Management System
ACTIVE LANE MANAGEMENT SYSTEM
The Active Lane Management button is located on the switch panel above the Uconnect display.
To turn the system on, push the Active Lane Management button (LED turns off). A message is shown in the instrument cluster display.
To turn the system off, push the button again (LED turns on).
NOTE:
The Active Lane Management system will retain the last system state on or off from the last ignition cycle when the ignition is placed in the ON/RUN position.
ACTIVE LANE MANAGEMENT WARNING MESSAGE
The Active Lane Management system will indicate the current lane drift condition through the instrument cluster display.
When the system is on, the lane lines are gray when both of the lane boundaries have not been detected.
Left Lane Departure — Only Left Lane Detected
- When the system is on and only the left lane marking has been detected, and the system is ready to provide visual warnings in the instrument cluster display and vibration and/or steering assist warning in the steering wheel if a lane departure occurs, the left lane line will be green.
- When the system senses the lane line has been approached (but not crossed), the left lane line will change to solid yellow and the system will provide a haptic steering wheel vibration and/or steering assist torque (if programmed in Ucon-nect Settings).
- When the system senses the lane line is being crossed, the left lane line will change to flashing yellow.
NOTE:
The Active Lane Management system operates with similar behavior for a right lane departure when only the right lane marking has been detected.
Left Lane Departure — Both Lanes Detected
- When the system is on, the lane lines turn from gray to green to indicate that both of the lane markings have been detected. When both lane markings have been detected, the system is ready to provide visual warnings in the instrument cluster display and a vibration and/or steering assist warning in the steering wheel if a lane departure occurs.
- When the system senses a lane drift situation, the left lane line turns solid yellow. At this time, steering assist warning is applied to the steering wheel in the opposite direction of the lane boundary.
For example: If approaching the left side of the lane the steering wheel will turn to the right. - When the system senses the lane line is being crossed, the left lane line changes from solid yellow to flashing yellow (on/off). At this time, vibration is applied to the steering wheel. For example: If approaching the left side of the lane the steering wheel will turn to the right.
NOTE:
- The Active Lane Management system operates with similar behavior for a right lane departure.
- If the turn signal is activated, and the vehicle begins to depart the lane at the same time the Blind Spot Monitoring (BSM) system detects another vehicle in the BSM zones, the system will provide a haptic steering wheel vibration and/or steering assist torque (if programmed in Uconnect Settings).
CHANGING ACTIVE LANE MANAGEMENT STATUS
Configurable settings for the Active Lane Management system are available within the Uconnect system Ú page 204.
Selectable Warning Types:
- Vibration Only
- Steering Assist Only
- Vibration And Steering Assist
Other configurable settings for this system are for the intensity of the vibration (high/med/low), steering assist warning (hi/med/low), and the warning zone sensitivity (early/medium/late).
NOTE:
- The system will not apply vibration and/or steering assist to the steering wheel whenever a safety system engages (Anti-Lock Brakes, Traction Control System, Electronic Stability Control, Forward Collision Warning, etc.).
- The Blind Spot Monitoring system will be forced on when the ALM system is enabled.
- The ALM system will be suppressed when the Active Driving Assist system (if equipped) is engaged.