Tucson

2022 Hyundai Tucson LCD Display Messages For Vehicles Equipped With Smart Key User Manual

2022 Hyundai Tucson LCD Display Messages For Vehicles Equipped With Smart Key User Manual

LCD Display Messages for Vehicles Equipped with Smart Key

Shift to P
This message is displayed if you try to turn off the vehicle without the gear in the P (Park) position. If this occurs, the Engine Start/Stop button turns to the ACC position.
Low key battery
When the Engine Start/Stop button is pressed to turn OFF the engine, this message may be displayed. This message indicates that the internal battery of the Smart Key is low. Consider replacing the Smart Key internal battery.
Press the START button while turning wheel
This message is displayed if the steering wheel does not unlock normally when the Engine Start/Stop button is pressed.
You should press the Engine Start/Stop button while turning the steering wheel right and left.
Check the steering wheel lock system
This message is displayed if the steering wheel does not lock normally while the Engine Start/Stop button is pressed to the OFF position.
Press brake pedal to start engine
This message is displayed if the Engine Start/Stop button changes to the ACC position twice by pressing the button repeatedly without depressing the brake pedal.
You can start the vehicle by depressing the brake pedal and then pressing the Engine Start/Stop button.
Key not in vehicle
This message is displayed if the smart key is not in the vehicle when you leave the vehicle with the Engine Start/Stop button in the ON or Start position.
Always turn off the engine before leaving your vehicle.
Key not detected
This message is displayed if the smart key is not detected when you press the Engine Start/Stop button.
Press START button again
This message is displayed if you were unable to start the vehicle when the Engine Start/Stop button was pressed. If this occurs, attempt to start the engine by pressing the Engine Start/ Stop button again.
If the warning message appears each time you press the Engine Start/Stop button, we recommend that you have the vehicle inspected by an authorized HYUNDAI dealer.

Press START button with key
This message is displayed if you press the Engine Start/Stop button while the warning message “Key not detected” is displayed.
At this time, the immobilizer indicator light blinks.
Check BRAKE SWITCH fuse
This message is displayed if the brake switch fuse is disconnected. You need to replace the fuse with a new one before starting the engine. If that is not possible, you can start the engine by pressing the Engine Start/Stop button for 10 seconds in the ACC position.
Shift to P or N to start engine
This message is displayed if you try to start the engine in any other position except P (Park) or N (Neutral).
Information
You can start the engine with the gear in N (Neutral). But, for your safety, we recommend that you start the engine with the gear shifted to P (Park).

Battery discharging due to external electrical devices
This message is displayed if the vehicle battery voltage is low or if a current draw is detected that could drain the vehicle battery. Check to see that there are no nonfactory external electronic devices connected to the vehicle battery system, otherwise battery discharge may occur. If this message appears in the LCD cluster and there are no other nonfactory electronic devices connected to the vehicle, have the vehicle inspected by an authorized HYUNDAI dealer.

Door, Hood, Liftgate open indicator

This warning is displayed if any door or hood or liftgate is left open. The warning will indicate which door is open in the display

CAUTION

  • Before driving the vehicle, you should confirm that the door/ hood/liftgate is fully closed.
  • Also, check there is no door/hood/liftgate open warning light or message displayed on the instrument cluster.

Sunroof open indicator (if equipped)

  • This warning is displayed if you turn off the engine when the sunroof is open.
  • Close the sunroof securely before leaving your vehicle.

Low tire pressure

This warning message is displayed if the tire pressure is low. The corresponding tire on the vehicle will be illuminated.
For more details, refer to “Tire Pressure Monitoring System (TPMS)” section in chapter 8.

Lights

This indicator displays which exterior light is selected using the lighting control.
You can activate or deactivate Wiper/Lights display function from the User Settings menu in the cluster LCD display.
Select:

  • Setup → User settings → Cluster → Wiper/Lights display

Wiper

  • This indicator displays which wiper speed is selected using the wiper control.
  • You can activate or deactivate Wiper/Lights display function from the User Settings menu in the cluster LCD display.
    Select:
  • Setup → User settings → Cluster → Wiper/Lights display

Low washer fluid (if equipped)
This message is displayed if the washer fluid level in the reservoir is nearly empty. Have the washer fluid reservoir refilled.
Low fuel
This message is displayed if the fuel tank is almost out of fuel.
When this message is displayed, the low fuel level warning light in the cluster will come on.
It is recommended to look for the nearest fueling station and refuel as soon as possible.
Low engine oil
This warning message is displayed when the engine oil level should be checked. If this warning message is displayed, check the engine oil level as soon as possible and add engine oil as required. Slowly pour the recommended oil little by little into a funnel.
Use only the specified engine oil. (Refer to the “Recommended Lubricants and Capacities“ section in chapter 2.) Do not overfill the engine oil. Make sure the oil level is not above F (Full) mark on the dipstick.

Engine overheated / Engine has overheated
This message is displayed when the engine coolant temperature is above 248°F (120°C). This means that the engine is overheated and may be damaged.
If your vehicle is overheated, refer to “Overheating” section in chapter 8.

Check headlight
This warning message is displayed if the headlamps are not operating properly. In addition, if a specific lamp(turn signal lamp etc.) is not operating properly, the warning message according to a specific lamp (turn signal lamp etc.) is displayed. A corresponding bulb may need to be replaced.
Make sure to replace the burned out bulb with a new one of the same wattage rating.

Check turn signal
This message is displayed if the turn signal lamps are not operating properly.A lamp may need to be replaced. Make sure to replace the burned out bulb with a new one of the same wattage rating.
Check headlamp LED
This message is displayed if there is a problem with the LED headlamp. We recommend that you have the vehicle inspected by an authorized HYUNDAI dealer.

Check Forward Collision-Avoidance Assist system
This warning message is displayed if there is a problem with Forward Collision-Avoidance Assist. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “Forward Collision-Avoidance Assist (FCA)” in chapter 6.
Check Lane Keeping Assist system
This warning message is displayed if there is a problem with Lane Keeping Assist. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “Lane Keeping Assist (LKA)” in chapter 6.
Check Blind-Spot Collision Warning system (if equipped)
This warning message is displayed if there is a problem with Blind-Spot Collision Warning. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “Blind-Spot Collision Warning (BCW) ” in chapter 6.

Check Driver Attention Warning system
This warning message is displayed if there is a problem with Driver Attention Warning. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “Driver Attention Warning (DAW)” in chapter 6.
Check High Beam Assist system
This warning message is displayed if there is a problem with the High Beam Assist. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “High Beam Assist (HBA)” in chapter 5.
Check Smart Cruise Control system (if equipped)
This warning message is displayed if there is a problem with Smart Cruise Control. Have the vehicle inspected by an authorized HYUNDAI dealer.
For more details, refer to “Smart Cruise Control (SCC)” in chapter 6.

Automotive Solutions

Recent Posts

VW Jetta Engine Fuse Box Diagram

Access the comprehensive 2010-2018 VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively.…

8 months ago

VW Jetta Passenger Fuse Box Diagram

Explore the comprehensive VW Jetta Passenger Fuse Box Diagram to troubleshoot electrical issues effectively. Understand…

8 months ago

2023 Ford F-150 Lightning Fuse Box Diagram

Under Hood Fuse Box Location Remove the front luggage compartment cover. Under Hood Fuse Box…

2 years ago

2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner’s Manual

2022 Kawasaki NINJA H2 SX SE Brake Lever Adjuster Owner's Manual NOTICE Only adjust the front…

2 years ago

2023 Land Rover Range Rover Evoque Exiting The Vehicle Owners Manual

2023 Land Rover Range Rover Evoque Exiting The Vehicle SINGLE LOCKING WARNING Before exiting the…

2 years ago

2023 Land Rover Range Rover Evoque Front Seats Owners Manual

2023 Land Rover Range Rover Evoque Front Seats FRONT SEAT SAFETY Make sure to read…

2 years ago