2023 Ford E-350 Jump Starting User Manual

Ford_logo

2023 Ford E-350 Jump Starting the Vehicle

2023 Ford E- product img

JUMP STARTING THE VEHICLE

  • WARNING: Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted substances to come near the battery. When working near the battery, always shield your face and protect your eyes. Always provide correct ventilation.
  • WARNING: Keep batteries out of reach of children. Batteries contain sulfuric acid. Avoid contact with skin, eyes or clothing. Shield your eyes when working near the battery to protect against possible splashing of acid solution. In case of acid contact with skin or eyes, flush immediately with water for a minimum of 15 minutes and get prompt medical attention. If acid is swallowed, call a physician immediately.
  • WARNING: Use only adequately sized cables with insulated clamps.

Preparing Your Vehicle

Do not attempt to push-start your automatic transmission vehicle.
Note: Attempting to push-start a vehicle with an automatic transmission may cause transmission damage.
Note: Use only a 12-volt supply to start your vehicle.
Note: Do not disconnect the battery of the disabled vehicle as this could damage the vehicle electrical system.
Park the booster vehicle close to the hood of the disabled vehicle, making sure the two vehicles do not touch.

Connecting the Jumper Cables

  • WARNING: Do not connect the negative jumper cable to any other part of your vehicle. Use the ground point.
  • WARNING: Make sure that the cables are clear of any moving parts and fuel delivery system parts.

2023 Ford E-350 Towing the Vehicle on Four Wheels FIG 4

Note: See the above image for your vehicle’s assigned ground connection point.

  1. Connect the positive (+) jumper cable to the positive (+) terminal of the discharged battery.
  2. Connect the other end of the positive (+) cable to the positive (+) terminal of the booster vehicle battery.
  3. Connect the negative (-) cable to the negative (-) terminal of the booster vehicle battery.
  4. Make the final connection of the negative (-) cable to the ground connection point.

Jump-Starting

  1. Start the engine of the booster vehicle and rev the engine moderately, or press the accelerator gently to keep your engine speed between 2000 and 3000 RPM, as shown in your tachometer.
  2. Start the engine of the disabled vehicle.
  3. Once the disabled vehicle has been started, run both vehicle engines for an additional three minutes before disconnecting the jumper cables.

Removing the Jumper Cables

Remove the jumper cables in the reverse order that they were connected.2023 Ford E-350 Towing the Vehicle on Four Wheels FIG 5

  1. Remove the negative (-) jumper cable from the disabled vehicle.
  2. Remove the jumper cable on the negative (-) terminal of the booster vehicle battery.
  3. Remove the jumper cable from the positive (+) terminal of the booster vehicle battery.
  4. Remove the jumper cable from the positive (+) terminal of the disabled vehicle battery.
  5. Allow the engine to idle for at least one minute.

Leave a Comment