2022 Kawasaki Z900 RS Brake Light Switches
Brake Light Switches
Brake Light Switch Inspection
- Turn the ignition switch on.
- The brake light should go on when the front brake is applied.
- If it does not, ask your authorized Kawasaki dealer to inspect the front brake light switch.
- Check the operation of the rear brake light switch by depressing the brake pedal. The brake light should go on after the proper pedal travel.
A. Brake Pedal
B. 10 mm (0.39 in.)
If the light does not come on, adjust the rear brake light switch.
Brake Pedal Travel
10 mm (0.39 in.)
Brake Light Switch Adjustment
Remove the rear master cylinder mounting bolts and guard.
A. Rear Master Cylinder Mounting Bolts
B. Guard
- Remove the right front footpeg bracket bolts.
- Pull the footpeg bracket a little bit outward.
A. Right Front Footpeg Bracket Bolts
B. Right Front Footpeg Bracket
- Slider the cover.
- To adjust the rear brake light switch, move the switch up or down by turning the adjusting nut.
A. Cover
B. Rear Brake Light Switch
C. Adjusting Nut
D. Lights sooner
E. Lights later
NOTICE
To avoid damaging the electrical connections inside the switch, be sure that the switch body does not turn during adjustment.
- Slide back the cover to the original position.
- Install the right front footpeg bracket.
- Tighten the right front footpeg bracket bolts to the specified torque.
Tightening Torque
Front Footpeg Bracket Bolts: 25 N•n-, (2.5 kgf•m, 18 ft•lb)
- Install the guard.
- Tighten the rear master cylinder mounting bolts to the specified torque.
Tightening Torque
Rear Master Cylinder Mounting Bolts: 25 (2.5 kgfrm, 18 ft-lb)
NOTE
- Depress the brake pedal and then align the holes of the master cylinder.
- lf a torque wrench is not available, this item should be serviced by an authorized Kawasaki dealer.