2022 Kawasaki Z125 Pro Air Cleaner
Air Cleaner
Air Cleaner Element Removal
Disconnect the horn lead connectors.
A. Horn Lead Connector (Brown/White Lead)
B. Horn Lead Connector (Black Lead)
- Slide the clamp and disconnect the hose.
- Remove the air cleaner cover screws and air cleaner cover.
A. Clamp
B. Hose
C. Air Cleaner Cover Screws
D. Air Cleaner Cover
Remove the air cleaner element and wire screen.
A. Air Cleaner Element
B. Wire Screen
- Put a clean, lint-free towel into the air-cleaner housing to keep dirt or other foreign material from entering.
- Inspect the element material for damage. If any part of the element is damaged, the element must be replaced.
WARNING
If dirt or dust is allowed to pass through into the throttle body assembly, the throttle may become stuck, possibly causing an accident. Be sure to keep the dust from entering during cleaning.
NOTICE
If dirt gets through into the engine, excessive engine wear and possibly engine damage will occur.
Air Cleaner Element Cleaning
- Clean the element in a bath of a high flash-point solvent.
- Squeeze it dry in a clean towel. Do not wring the element or blow it dry; the element can be damaged.
- Check the element for visible damage.
- If the element is damaged, replace it.
- After cleaning, saturate the element with high-quality foam-air-filter oil, squeeze out the excess oil, then wrap it in a clean towel and squeeze it as dry as possible.
- Be careful not to tear the element.
WARNING
Gasoline and low flash-point solvents are extremely flammable and may explode, causing severe burns. Do not use gasoline or a low flash-point solvent to clean the element. Clean the element in a well-ventilated area. Be sure there are no sparks or flames in the work area, including any appliance with a pilot light.
Air Cleaner Element Installation
- Before installation, check the element for damage such as tears, hardening, or shrinkage. If damaged, replace the element.
- Remove the towel from the air cleaner housing.
- Apply grease to the lateral side of the element (grid area) as shown.
- Install the wire screen and air cleaner element.
A. Lateral Side Of the Element (Grid Area)
B. 10 mm (0.39 in.) from the end.
C. Element
D. Wire Screen
- Install the air cleaner cover.
- Tighten the air cleaner cover screws to the specified torque.
Tightening Torque
Air Cleaner Cover Screws: 1.2 (0.12 kgfrm, II in•lb)
Connect the hose and slide the clamp to the original position.
NOTE
When connecting the hose, avoid sharp bending.
A. Hose
B. Clamp
C. Do not bend sharply.
- Connect the horn lead connectors to the original position.
- Check the horn sounds normal.
A. Horn Lead Connector (Brown/White Lead)
B. Horn Lead Connector (Black Lead)