2022 Land Rover Discovery Sports Storage Compartments
STORAGE COMPARTMENTS
Make sure that any items stored in the vehicle are secure and cannot move. If the vehicle is involved in an accident or is subject to sudden braking or a change of direction, loose items can cause serious injury.
Storage compartment locations:
- Sunglasses tray.
- Glovebox: Pull the handle to open.
- Armrest and cubby box: Pull the release lever and raise the armrest to access the storage area.
WARNING
To avoid personal injury, keep hands and fingers clear from the front and rear edges of the armrest during the opening and closing of the cubby box.
- Removable front cupholders: To remove the cup holder assembly, open the cubby box lid and pull the release handle on the rear end of the assembly.
NOTES
A hidden storage area is located under the cup holder assembly.
WARNINGDo not drink while driving. Driver distraction can lead to accidents, potentially causing serious injury or death.
WARNINGDo not remove items from, or place items in, the cup holders while driving. Driver distraction can lead to accidents, potentially causing serious injury or death.
- Removable coin tray: The removable coin tray can be stored vertically in the cubby box.
- Rear armrest storage and cup holders: Press the release button to access the storage area.
- Front door storage areas.
- The storage bin is located at the rear end of the center console.
- Rear door storage areas.
- Luggage compartment storage area.
Do not drink while driving. Driver distraction can lead to accidents, potentially causing serious injury or death.
Do not remove items from, or place items in, the cup holders while driving. Driver distraction can lead to accidents, potentially causing serious injury or death.
The fitment of third-row cup holders depends on the vehicle’s specifications.
AUXILIARY POWER SOCKETS
Only use approved accessories. Using any other equipment may damage the vehicle’s electrical system and/or cause the battery to discharge. If in any doubt, contact a retailer/authorized repairer.
The engine should be running when using accessories for long periods. Failure to do so can discharge the battery.
There are 12V power sockets and 5V USB charge sockets equipped for the vehicle.
The 12V power sockets can be used to power approved accessories that use a maximum of 120 Watts.
12V and 5V socket locations:
- 5V USB socket located below the climate and comfort controls.
- 12V power socket located inside the center console’s cubby box.
NOTES
Depending on the vehicle specification, a cigar lighter may be equipped instead of the 12V power socket.
- Two 5V USB sockets and one 12V power socket, or a single 12V power socket at the rear of the center console.
- The power socket is located on the seatbacks of the front driver and passenger seats.
NOTES
The passenger side USB socket is not fitted if the vehicle has the third-row seat Air Conditioning (A/C) control.
- 12V and 5V power sockets are located in the loadspace.
Socket locations are dependent on the specification of the vehicle.
WIRELESS CHARGER
Metallic objects may become hot if they are placed between the mobile device and the charging mat, which may result in serious injuries.
Do not place anything other than a Qi-compatible mobile device or accessory onto the charging mat. Items such as keys, key fobs, coins, jewelry, paperclips, or foil candy wrappers may interfere with the wireless charger operation.
The wireless charger is located on the center console, beneath the climate controls. See DRIVER CONTROLS. The wireless charger provides up to 15 Watts of power to charge Qi-compatible mobile devices.
To use the wireless charger:
- Switch on the vehicle’s ignition.
- Place the Qi-compatible mobile device in the center of the mat with the device’s screen facing upward. Align the long edge of the device with the longer edge of the wireless charging area. Charging commences after a short delay of up to 10 seconds.
Remove the mobile device from the wireless charger to stop the charging process.
The amount of charging current supplied and the time taken for charging is entirely under the control of the mobile device.
The wireless charger continues to charge during an engine stop/start event.
Aftermarket device cases or enclosures can reduce wireless charging efficiency, or block it altogether. If a Qi-compatible device exhibits problems charging wirelessly, remove any aftermarket cases or enclosures.
Removing the device from the wireless charging mat and replacing it will reset the connection.
Dynamic driving could cause the device to move around in the wireless charging area. This may cause the wireless charge process to disconnect briefly. Make sure the device remains flat on the wireless charging mat. The wireless charger switches off automatically when the mobile device is fully charged.
The following icons appear on the touchscreen and relate to the wireless charging status:
Charging: Indicates a device is on the charging mat and recognized by the system.
Charged: Indicates the mobile device is fully charged.
Foreign object: Indicates a foreign object is detected on the charging mat. Occasionally, the wireless charging system may display this symbol while cooling down. Wireless charging will resume once the system’s temperature has normalized.
The wireless charger mat incorporates a phone signal booster. The phone signal booster is a cell phone signal enhancer, designed to compensate for reduced reception inside the vehicle’s interior. This phone signal booster operates by selectively boosting signals into and out of the cell phone via an external antenna. The phone signal booster operates automatically when a cell phone is placed on the charging mat; there is no need to connect or set up the phone signal booster.
Enhanced 911 (E-911) location information may not be provided or may be inaccurate for calls served when using this device.
This signal booster is a consumer device. Before use, you must register this device with your wireless provider and have your provider’s consent. Please contact your retailer to obtain the device’s serial number. Once obtained, contact your wireless service provider to register the phone signal booster.
You MUST cease operating this device immediately if requested by the FCC (USA) or ISED (Canada) or a licensed wireless service provider.
Canada only – Before use, you must meet all requirements set out in ISED CPC-2-1-05. See https://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf08942.html for details. You must operate this device with approved antennas and cables as specified by the manufacturer. Antennas must not be installed within 8 in (20 cm) of any person.
The phone signal booster cannot enhance cell phone reception in areas where there is no signal available.