2022 Jeep Grand Cherokee TrailCam User Guide

Jeep-logo

2022 Jeep Grand Cherokee TrailCam User Guide

TRAILCAM SYSTEM

The TrailCam system allows you to you see an on-screen image of the front view of your vehicle. The image will be displayed on the Uconnect display along with a caution note “Check Entire Surroundings” across the top of the screen.2022 Jeep Grand Cherokee TRAILCAM SYSTEM — IF EQUIPPED fig 1

NOTE

  • The system will stay active while in 4WD Low.
  • The TrailCam system has programmable settings that may be selected through the Uconnect system.

Manual Activation Of The TrailCam

TrailCam view can be activated via the following methods:

  • Press the FWD Camera button on the controls screen.
  • Press the Forward Facing Camera button on the apps menu.
  • Press the TrailCam button on the Off-Road Pages.

The TrailCam view can also be activated by pressing the icon on the Back-Up Camera view. The Back-Up Camera view can also be activated by
pressing the icon on the TrailCam view. When the vehicle is shifted out of REVERSE with camera delay turned off and TrailCam view is active, the TrailCam mode is exited and the previous screen appears again. When the vehicle is shifted out of REVERSE with camera delay turned on and the TrailCam view is active, the TrailCam image will be displayed for up to 10 seconds unless the vehicle speed exceeds 8 mph (13 km/h), the transmission is shifted into PARK, the ignition is placed in the OFF position, or the touchscreen button X to disable the display of the TrailCam view is pressed.

NOTE

  • If the vehicle speed remains below 8 mph (13 km/h) while in 2WD or 4WD High, the TrailCam image will be displayed continuously until deactivated via the touchscreen button X, the transmission is shifted into PARK, or the ignition is placed in the OFF position.
  • The touchscreen button X to disable the display of the camera image is made available ONLY when the vehicle is not in REVERSE.
  • The TrailCam view will stay active regardless of the vehicle speed and time while in 4WD Low.

Cleaning The TrailCam

Press and hold the Clean Camera soft button located on the TrailCam view to wash the TrailCam. Washer fluid will stop when the button is released. The camera can be washed up to 20 seconds at a time while holding the button.

NOTE

  • Pressing the Clean Camera soft button will also wash the Night Vision camera (if equipped).
  • If the front window washer feature is activated, all of the front cameras on the vehicle will be washed as well. The front camera washers will not operate when the low washer fluid warning is displayed.
  • Due to washer pump packaging, the front camera washers will run out of fluid before the Low Washer Fluid Warning Light is activated. When the front camera washers stop functioning, add fluid to the washer fluid reservoir to resume function.

When enabled, active dynamic Tire Lines are projected on the ground plane of the TrailCam view based on the steering wheel position.

Leave a Comment