2022 Subaru Ascent Engine Overheating
Engine overheating
WARNING
Never remove the radiator cap until the engine has been shut off and has fully cooled down. When the engine is hot, the coolant is under pressure. Removing the cap while the engine is still hot could release a spray of boiling hot coolant, which could burn you very seriously.
CAUTION
If the engine overheats, the engine speed or the vehicle speed may be reduced. Stop the vehicle in a safe place immediately.
If steam is coming from the engine compartment
- Turn the ignition switch to the “LOCK”/ “OFF” position and get everyone away from the vehicle until it cools down. . Contact an authorized SUBARU dealer.
If no steam is coming from the engine compartment
- Keep the engine running at idling speed.
- Open the engine hood to ventilate the engine compartment. Refer to “Engine hood” P447.
Confirm that the cooling fan is turning. If the fan is not turning, immediately turn off the engine and contact an authorized SUBARU dealer for repair. - After the engine coolant temperature has dropped, turn off the engine. If the temperature gauge stays in the overheated zone, turn off the engine.
- After the engine has fully cooled down, check the coolant level in the reserve tank. If the coolant level is below the “LOW” mark, add coolant up to the “FULL” mark.
NOTE
For details about how to check the coolant level or how to add coolant, refer to “Engine coolant” P453. - If there is no coolant in the reserve tank, add coolant to the reserve tank. Then remove the radiator cap and fill the radiator with coolant.
If you remove the radiator cap from a hot radiator, first wrap a thick cloth around the radiator cap, then turn the cap counterclockwise slowly without pressing down until it stops. Release the pressure from the radiator. After the pressure has been fully released, remove the cap by pressing down and turning it.